Dymo PS2R1-1P Manual do Utilizador

PS2R1-P Chip Replacement InstructionsThe PS2R1-1P is a rate programmable scale. It is not necessaryfor you to buy a chip. Let’s take a look at how t

First turn the scale on. The scale must remain on whilechanging the rate chip to retain the memory.Turn the scale upside down

Remove the battery rate chip compartment cover from the bottom of the scale.Note the direction of the old chip.You will see the notch on the top surfa

Using a flat head screwdriver gently pry one side upand the other side to remove the chip. Lift the chip straight up and out of the socket.

Be careful that the notch is on the correct side of the socket.Check that each pin will slip into the socket.Now place the new rate chip in the socket

Gently press down to seat the chip into the socket.Replace the battery rate chip compartment cover.

Turn the scale over, press the count key…The scale will show ACCP , AD10 or PC.

Turn the scale off.Turn the scale back on.

If the new rate chip has been installed correctly the scale willautomatically go through its self check operationshowing a four digit version code num